The Microphone is a low profile boundary layer through table design with a Cardioid polar pattern. The Microphone is motor driven and has the ability to automatically retract leaving only 3mm (0.12″) protruding above the surface. The integral motor requires the control module ARM-C to operate.
A control signal (+2.5V – 12V) from a DSP or Electronic Switch are required to activate the RETRACTA. The microphone is engineered in high quality brass for long life and smooth running. The Microphone has an integral electronic module which requires a 9 – 48 volt Phantom Power supply.
The module is fitted with filters which will eliminate all GSM frequencies from 800 – 1200MHz, Impedance 200Ohms, Frequency Response 50Hz – 18KHz, Sensitivity -37 ± 3dB @ 1Kz (0dB = 1V/Pa), MSP 120dB THD is no greater than 1%. The Microphone connections: Audio is a 2 meter (6.6ft) open ended 2 core and screen cable. Motor control is a 2 meter (6.6ft) Cat 5 cable fitted with an RJ45.
Finish: Black Nextel® or Satin Nickel.
Use the Data sheet button on this page for the full specification PDF, and check the Downloads tab for manuals and other documents.
Available finish: Satin Black or Nickel
It uses a Cardioid Frequency Response 50Hz - 18 KHz polar pattern.
The ARM 102-RF is a Condenser (Back Electret)
Our audio engineers can help you specify the perfect microphone for your installation. Get in touch for expert guidance.
