The condenser microphone design is for a through desk/ceiling/panel mount boundary layer type with a cardioid polar pattern. The microphone is made of a robust high quality brass construction with a low profile robust brass top. It is terminated with a male 3 Pin XLR.
The microphone is powered by a 9 to 48 volts phantom power adaptor which also includes filters that will eliminate all GSM frequencies from 800-1200 MHz Frequency response 50 Hz to 18 KHz; Sensitivity -37dB +/- 3dB @ 1Khz (0dB=1V/Pa) Impedance 200 Ohms. Total harmonic distortion (THD) at an operating level of 120dB is no greater than 1%. Also included are rubber shock mounts to minimize the transfer of mechanical noise from table, ceiling or panel.
Length 90.00mm (3.55″).
Dimensions: Hole cut out Diameter: 24mm (0.94") Head Diameter:28.00mm (1.10")
Termination: Male 3 Pin XLR
Our audio engineers can help you specify the perfect microphone for your installation. Get in touch for expert guidance.